EC13006634
SLAC 12036
The Edco Slac series suppressor was specifically designed to protect electronic instruments by the water and waste water industry. It combines hybrid AC power protection and signal line protection in a NEMA 4X polycarbonate enclosure. Edco is the only company to offer this dual protection.
PC642C-036
The PC Series surge suppressor is a dual pair module implementing three stage hybrid technology. This module addresses over voltage transients with gas tubes and silicon avalanche components. In addition, sneak and fault currents are mitigated with resettable fuses, PTCs. PTCs increase resistance several orders of magnitude when overcurrents exceed safe levels. A normal state resumes when overcurrents are removed. The ability to self restore in this manner significantly increases suppressor performance and survivability.
The PC642 card edge module is gold-plated, double sided and is designed to mate with the PCB1B gold-plated female terminal connector. When snapped together, the data circuits pass through the protector in a serial fashion from the four field terminals to the four electronics side terminals. Terminals 1 or 10 of the PVCB1B must be attached to building approved ground per Edco technical bulletin #2015.
SS64 & SS65
The Edco SS64 and SS65 Series suppressors are designed for the water and waste water industry. These muti-stage hybrid suppressors address over voltage transients with gas tube and silicon avalanche technology. In addition, sneak and fault currents are mitigated with new PTC devices which consist of solid state resettable fuses. The units are encapsulated in stainless steel pipe nipples making them suitable for use in severe environments. The SS64 models protect a signal pair and the SS65 models protect a signal pair plus the cable shield.
HSP121BT-1RU
The Edco HSP121BT-1RU is an advanced 3 stage hybrid, solid state power line protector. Features such as noise filtering, common mode and normal mode suppression, nanosecond reaction time, power line tracking, and compressions screw terminations make the HSP121BT-1RU an excellent choice in commercial and industrial applications.
The HSP121BT-1RU offers a replaceable fuse designed to remove the protected equipment from the line if the unit is either overloaded or the internal protection fails. This feature prevents surges from entering equipment through a failed protector, not noticed by the user. Unlike models with only an indicator, which may take two weeks to notice, the HSP121BT-1RU demands immediate attention upon the unlikely occurrence of internal failure.
Edco Surge Protection Equipment.
Edco Surge
| Electrical |
| Fuel Systems |
| Infrared |
| Telecommunications |
| Lightning / Surge |
| Edco Surge |